Rotating discharge body for easy installation. Valves designed to prevent backflow.

Features: Manual

• The Rule LP900D Bilge Pump is a low profile pump with 900 gallons per hour capacity
• Designed for tight spaces, the height of the pump is only 2-1/4″
• It features a threaded discharge nozzle to which you can attach either the included straight or 90° fitting
  • Multiple ports are available for this pump
  • All ports are included
    • 3/4″ Straight
    • 3/4″ Right angle
    • 1″ and 1-1/8″
• It also includes a tricuspid check valve for the straight fitting which can be used to minimize the back flow of water
• The entire discharge body swivels up to 180° for ease of installation
• The hose can also swivel 360° for better routing
• The 900D model requires a float and/or panel switch (Sold Separately)

Features: Automatic

• The Rule LP900S Automatic Bilge Pump is a low profile pump with 900 gallons per hour capacity
• Designed for tight spaces, the height of the pump is only 2-1/4″
• It features a threaded discharge nozzle to which you can attach either the included straight or 90° fitting
  • Multiple ports are available for this pump
  • All ports are included
    • 3/4″ Straight
    • 3/4″ Right angle
    • 1″ and 1-1/8″
• It also includes a tricuspid check valve for the straight fitting which can be used to minimize the back flow of water
• The entire discharge body swivels up to 180° for ease of installation
• The hose can also swivel 360° for better routing
• The LoPro LP900S has (2) Automated settings, enabling the pump to turn on when the water reaches either 2″ or 1.3″
  • High or Low Water Sensing Mode:
    • The pump starts when water reaches a 2″ level
    • By turning the motor cartridge upside down, the sensor is set at 1.3″
  • Electronic Automatic Mode:
    • The pump automatically turns on every 2.5 minutes to check for water, and if it’s detected the pump stays on until the water is gone